Posted by pakos on April 09, 2003 at 10:13:53:
Hey guys.
I have another question that i have forgotten to post previously. After assembling the engine and setting the correst timing, adjusting the valves etc i looked in clymers manual and saw that he is showing a timing gun in the first section with the usefull tools. Is it possible to adjust the engine by using that gun and if yes how and what is the correct angle of ignition before tdc.
In addition i dissassembled the side stand interlock switch since it was all covered in oil and stuff and now it works. The thing is, i dont know how its connected to the side stand it self. I mean i connected it to the frame but even with the side stand up it doesnt even get near of pushing that switch. Is it connected by means of a spring or am i doing something wrong.
Just to check if it is working or not i asked someone to hold it in the open position and with a gear in and the bike was still starting. Does that mean that the relay is burned and if yes does anyone know how much approximately it will cost.
Thanks once again.